Proxim wireless ORiNOCO AP-4000MR-LR Przewodnik Instalacji Pobierz pdf (Strona 22)

Set c. IP Address Type to Static.

Enter a static IP Address for the AP in the eld provided. You d.

must assign the unit a unique address that is valid on your IP

subnet.

Enter your network’s e. Subnet Mask.

Enter your network’s f. Gateway IP Address.

Enter the SNMP read/write password in the g. Read/Write

Password eld. For new units, the default password is public

Click h. OK to save your changes.

The Access Point will need to reboot to apply any changes you i.

made. When the reboot message appears, click OK to reboot the

device and return to the Scan List screen.

After allowing sufcient time for the device to reboot, click j.

Rescan to verify that your changes have been applied.

Click the k. Change button to return to the Change screen.

Click the l. Web Conguration button at the bottom of the

Change screen.

Proceed to the m. Logging In section, below.

Logging In

Once the AP has a valid IP Address and an Ethernet connection, you may use

your web browser to monitor and congure the AP. (To congure and monitor

using the command line interface, see the AP-4000MR-LR/4900MR-LR User

Guide.)

Open a Web browser on a network computer. 1.

If necessary, disable the browser’s Internet proxy settings. 2.

Enter the Access Point’s IP address in the browser’s 3. Address eld and

press Enter or Go. This is either the dynamic IP address assigned by a

network DHCP server or the static IP address you manually congured. See

the Using ScanTool section above for information on how to determine the

unit’s IP address and manually congure a new IP address, if necessary.

The login screen appears.4.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Brak uwag

Proxim wireless ORiNOCO AP-4000MR-LR Przewodnik Instalacji Strona 22